Heat SEAL - 19" X 1 Yard

HeatSEAL will be your answer for smaller runs of patches, emblems, and badges. This film will be attached to the backside of a finished embroidered image. 

It's recommended to accompany our 'Patch-Mat' material, giving you the ability to cut out the patch with a hot knife. All edges will be nicely sealed. The finished edge will not look quite like a patch that has gone through a 'merrowing' machine but will stay together and be the best you can produce in smaller quantities from start to finish. 
HeatSEAL can then give the end-user the choice to iron-on or heat-press the patch to the garment(textile) or become a 'sewn-on' patch. A hook-n-loop type attachment is also a viable choice. 

Comes in a 19" by one-yard sheet. Also available in a 10-yard roll and in a 100-yard roll. 
Product thickness: 7mil 

To bond HeatSEAL to the back of the emblem/patch material: 
320-330 degrees / 40-50 psi / 10 seconds press time/flip and press again 

To bond patch to garment: 
320-330 degrees / 60-80 psi / 10-15 seconds press time on the front side/flip and press from the back side 20-25 seconds